Removing and replacing the 8 SFF drive backplaneRemoving and replacing the 8 SFF drive backplane
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
Remove the server from the rack .
4. Remove the access panel.
5. Remove the fan cage.
6. Remove all drives .
7. Disconnect all cables from the drive backplane.
8. Remove the drive cage.
9. Remove the drive backplane.
To Next Page
Loading...
