Removing and replacing the 2 SFF rear drive backplaneRemoving and replacing the 2 SFF rear drive backplane
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Remove the server from the rack
4. Remove the access panel.
5. Remove all drives .
6. Disconnect all cables from the drive backplane.
7. Remove the secondary riser cage.
8. Remove the drive backplane.
To replace the component, reverse the removal procedure.
To Next Page
Loading...
