HP ProLiant DL360 G6 - Page 64

Hardware options installation 64
HP NC522SFP Dual Port 10GbE Server Adapter
option
To install the component:
1. Power down the server (on page 20).
2. Extend the server from the rack (on page 20).
3. Remove the access panel (on page 22).
4. Remove the PCI riser board assembly (on page 24).
5. Remove expansion slot cover 1 from the PCI riser board assembly.
6. Install the adapter in slot 1 on the PCI riser board assembly.
7. Install the PCI riser board assembly (on page 25).
8. Install the access panel (on page 22).
9. Slide the server into the rack.
10. Power up the server (on page 20).
Redundant hot-plug power supply option
CAUTION: All power supplies installed in the server must have the same output power
capacity. Verify that all power supplies have the same part number and label color. The
system becomes unstable and may shut down when it detects mismatched power supplies.
Label color Output
Blue 460W
Orange 750W
Green 1,200W