Removal and replacement procedures 40
7.
Remove the battery.
IMPORTANT: Replacing the system board battery resets the system ROM to its default
configuration. After replacing the battery, reconfigure the system through RBSU.
To replace the component, reverse the removal procedure.
For more information about battery replacement or proper disposal, contact an authorized reseller or an
authorized service provider.
System board
To remove the component:
1. Power down the server (on page 13).
2. Remove the server from the rack (on page 14).
3. Remove the access panel ("Access panel" on page 16).
4. Remove all hard drives ("SAS and SATA hard drive" on page 18).
5. Remove all power supplies ("Hot-plug power supply" on page 19).
6. If installed, remove the BBWC battery pack or the FBWC capacitor pack ("BBWC battery pack or
FBWC capacitor pack" on page 25).
7. Remove the air baffle ("Air baffle" on page 26).
CAUTION: To prevent damage to the server or expansion boards, power down the server
and remove all AC power cords before removing or installing the PCI riser board assembly.
8. Remove the PCI riser board assembly ("PCI riser board assembly" on page 26).
9. Remove all fan modules ("Fan module" on page 23).
10. Remove the fan blank ("Fan blank" on page 24).
11. Disconnect all cables connected to the system board ("System board components" on page 57). For
more information, see "Cabling (on page 46)."
12. Remove the cache module ("Cache module" on page 29).
To Next Page
Loading...
