HP ProLiant DL360 Generation 5 - Page 35

Removal and replacement procedures 35
5.
Remove any expansion board installed in the assembly.
To replace the component, reverse the removal procedure.
PCI Express riser board
To remove the component:
1. Power down the server (on page 26).
2. Extend or remove the server from the rack ("Extend the server from the rack" on page 26, "Remove
the server from the rack" on page 27).
3. Remove the access panel ("Access panel" on page 27).
4. Remove the PCI riser board assembly ("PCI riser board assembly" on page 33).
5. Remove all expansion boards. ("PCI-X or PCI Express expansion board" on page 34)
6. Remove the full-length PCI Express riser board from the riser board assembly.