Removal and Replacement Procedures
Compaq ProLiant DL360 Server Maintenance and Service Guide 2-23
COMPAQ CONFIDENTIAL Codename: MicroMachine Part Number: 169616-006 Last Saved On: 12/31/01 11:05 AM
Expansion Board (64-Bit Slot)
To remove an expansion board from a 64-bit slot:
1. Complete the preparation procedures. See “Powering Down the Server” earlier in this
chapter.
2. Remove the access panel. See “Server Access Panel” earlier in this chapter.
3. Remove the PCI riser board assembly. See “PCI riser board assembly” earlier in this
chapter.
4. Slide the expansion board retaining clip out from the assembly
.
5. Slide the expansion board out of the 64-bit expansion slot
.
6. Slide the expansion board retaining clip back into the assembly
.
1
2
3
Figure 2-18: Removing an expansion board from the 64-bit
expansion slot
To Next Page
Loading...
