Removal and replacement procedures 32
6.
Connect the power cord to the power source.
7. Be sure that the power supply LED is green.
8. Be sure that the power supply LED on the SID is green ("Systems Insight Display LEDs" on page 79).
Optical drive
To remove the component:
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
1. Power down the server (on page 24).
2. Extend the server from the rack (on page 25).
3. Remove the access panel ("Access panel" on page 29).
4. Disconnect the cable from the optical drive.
To Next Page
Loading...
