Removal and replacement procedures 45
To replace the component, reverse the removal steps. When re-installing the fans, press down on the top of
each fan to be sure it is seated properly.
Expansion slot covers
CAUTION: To prevent damage to the server or expansion boards, power down the server and
remove all AC power cords before removing or installing the PCI riser cage.
CAUTION: For proper cooling, do not operate the server without the access panel, baffles,
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
1. Power down the server (on page 24).
2. Extend the server from the rack (on page 25).
3. Remove the access panel ("Access panel" on page 29).
4. Remove the PCI riser cage ("PCI riser cage" on page 40).
5. Remove the expansion slot cover:
o To remove slot cover 1 or 4, push in on the retainer to release it, and then slide out the cover.
To Next Page
Loading...
