HP ProLiant DL380 - Page 86

86 HP ProLiant DL380 Generation 3 Server User Guide
5. Connect the power cord to the power supply.
6. Route the power cord through the cable management arm or power cord
anchor.
NOTE: If using the power cord anchor, be sure to leave enough slack
in the power cord so that the redundant power supply can be removed
without disconnecting the power cord from the primary power supply.
7. Lock the cable management arm into the operating position.
8. Connect the power cord to the power source.
9. Be sure that the power supply LED is green ("Rear Panel LEDs and Buttons"
on page 15).
10. Be sure that the front panel external health LED is green ("Front Panel LEDs
and Buttons" on page 11).
HP CONFIDENTIAL
File Name: 303130-3.doc Last Saved On: 7/7/03 1:48 PM