Removal and replacement procedures 76
10.
Apply all the grease to the top of the processor in the following pattern to ensure even distribution.
11. Install the heatsink.
12. Install all components removed from the failed system board.
13. Install the access panel ("Access panel" on page 33).
14. Install the power supplies ("Hot-plug power supply" on page 31).
15. Power up the server.
IMPORTANT: Install all components with the same configuration that was used on the failed
system board.
After you replace the system board, you must re-enter the server serial number and the product ID.
1. During the server startup sequence, press the F9 key to access RBSU.
2. Select the Advanced Options menu.
3. Select Service Options.
4. Select Serial Number. The following warnings appear:
To Next Page
Loading...
