HP ProLiant DL385p Gen8 - Setup; Environmental, Power, and Grounding Requirements

Removal and replacement procedures 36
6.
Remove the PCIe riser cage.
To install the component, reverse the removal procedure.
Remove the secondary PCIe riser cage
CAUTION: To prevent damage to the server or expansion boards, power down the server and
remove all AC power cords before removing or installing the PCIe riser cage.
To remove the component:
1. Power down the server (on page 26).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Extend the server from the rack (on page 27).
4. Remove the access panel ("Access panel" on page 32).