10. Install the OCP NIC 3.0 adapter:
a. Rotate the locking pin to the open (vertical) position (callout 1).
b. Slide the adapter into the bay until it clicks into place (callout 2).
Make sure that the adapter is seated firmly in the slot.
c. Rotate the locking pin to the close (horizontal) position (callout 3).
11. Connect the OCP bandwidth upgrade cables .
12. Install the riser cage.
13. Install the access panel .
14. Install the server into the rack .
15. Connect all peripheral cables to the server.
16. Connect each power cord to the server.
17. Connect each power cord to the power source.
18. Power up the server .
ResultsResults
The installation is complete.
Power distribution boardPower distribution board
The power distribution board (PDB) supports the installation of power supplies 3 and 4.
SubtopicsSubtopics
Installing the PDBInstalling the PDB
To Next Page
Loading...
