Installing the Server in a Rack
2. Secure the retaining clip onto the power cord.
Figure 8-13: Securing the retaining clip
Attaching the Cable Management Arm
The cable management arm ships with a round-hole bracket and a square-hole
bracket. Use the appropriate bracket instructions for the server rack.
Attaching the Cable Management Arm to a Square-Hole Rack
IMPORTANT: If attaching the cable management arm to a round-hole rack, refer to “Attaching
the Cable Management Arm to a Round-Hole Rack.”
1. Slide the bracket onto the rack (1).
2. Insert the bracket hooks into the square holes on the rack, and then push down to
secure (2).
3. Tighten the thumbscrew to stabilize the cable management arm on the rack (3).
HP ProLiant DL580 Generation 2 Server Setup and Installation Guide 8-17
HP CONFIDENTIAL
Writer: Karen Hale File Name: i-ch8 Installing the Server in a Rack.doc
Codename: Wave Part Number: 230835-003 Last Saved On: 6/26/03 9:41 AM
To Next Page
Loading...
