Removal and replacement procedures 29
iii.
Slide the server out of the enclosure.
3. After performing the installation or maintenance procedure, slide the server back into the enclosure,
and then press the server firmly into the enclosure to secure it in place.
4. Do one of the following:
o In a server that uses thumbscrew rack ears, tighten the captive thumbscrews.
o In a server that uses quick-release latch rack ears, if necessary, tighten the shipping screws.
5. If the rear panel cables were disconnected because a cable management arm is not in use, do the
following:
a. Connect each power cord to the server.
b. Connect all peripheral cables to the server.
c. Power up the server.
To Next Page
Loading...
