HP Smart Array errors 114
Log message: The <drive type> physical hard drive located in bay <bay number> is
not supported <not supported reason>. This drive can be found in box <box number>
which is connected to port <port number> of the array controller <controller name
/ slot information>.
<not supported reason> values:
• “because it is a singled ported drive”
• “because it is a SATA drive”
• “because it is smaller than the drive it is replacing”
• “because it is of an unrecognized type”
• “because it contains an unsupported RIS configuration”
Message Id: 24598
Severity: Informational
Log message: Logical drive <logical drive number> of array controller <controller
name / slot information> has encountered a status change from:
Status: <previous status>
to
Status: <current status>
<previous status> and <current status> values:
• “OK”
• “FAILED”
• “NOT CONFIGURED”
• “INTERIM RECOVERY MODE”
• “READY FOR RECOVERY”
• “RECOVERING”
• “WRONG PHYSICAL DRIVE REPLACED”
• “PHYSICAL DRIVE NOT PROPERLY CONNECTED”
• “HARDWARE IS OVERHEATING”
• “HARDWARE HAS OVERHEATED”
• “EXPANDING”
• “NOT YET AVAILABLE”
• “QUEUED FOR EXPANSION”
• “DISABLED DUE TO SCSI ID CONFLICT”
• “EJECTED”
• “ERASING”
• “UNKNOWN”
Message Id: 24599
Severity: Warning
To Next Page
Loading...
