HP ProLiant Gen9 - Page 195

HP Onboard Administrator errors 195
OA: Blade [value:bladeNumber] Internal Temperature Sensor fault...state is
CRITICAL.
OA: Blade [value:bladeNumber] Internal Temperature Sensor fault...state is
DEGRADED.
OA: Blade [value:bladeNumber] is not properly cooled.
OA: Blade [value:bladeNumber] is not supported.
OA: Blade [value:bladeNumber] is reporting degraded health status.
OA: Blade [value:bladeNumber] is reporting failed health status.
OA: Blade [value:bladeNumber] Main Logic Board fault...state is CRITICAL.
OA: Blade [value:bladeNumber] Main Logic Board fault...state is DEGRADED.
OA: Blade [value:bladeNumber] needs a partner device.
OA: Blade [value:bladeNumber] over temperature...state is CRITICAL.
OA: Blade [value:bladeNumber] over temperature...state is DEGRADED.
OA: Blade [value:bladeNumber] PCI device missing...state is CRITICAL.
OA: Blade [value:bladeNumber] PCI device missing...state is CRITICAL.
OA: Blade [value:bladeNumber] PCI device missing...state is DEGRADED.
OA: Blade [value:bladeNumber] PCI device missing...state is DEGRADED.
OA: Blade [value:bladeNumber] Power Control fault...state is CRITICAL.
OA: Blade [value:bladeNumber] Power Control fault...state is DEGRADED.
OA: Blade [value:bladeNumber] properly partners with its neighbor.
OA: Blade [value:bladeNumber] reported an unusually high power allocation value.
Please see customer advisory c01668472. Its invalid power value of [value]W has
been capped at [value]W.
OA: Blade [value:bladeNumber] requested too little power.
OA: Blade [value:bladeNumber] Storage Condition fault...state is CRITICAL.
OA: Blade [value:bladeNumber] Storage Condition fault...state is DEGRADED.
OA: Blade [value:bladeNumber] thermal state is CRITICAL.
OA: Blade [value:bladeNumber] thermal state is DEGRADED.
OA: Blade in bay #[value:bladeNumber] status changed from [OK/Degraded/Failed]
to [OK/Degraded/Failed]
OA: Blade in bay #[value:bladeNumber] status changed to [OK/Degraded/Failed]
OA: Blade removed from bay [value:bladeNumber]
OA: Blade removed from bay [value:bladeNumber]
OA: DC Subsystem Overload - FAILED. Redundant Power: [value]W DC, Present Power
[value]W AC.
OA: Ekeying: Partner device of blade [value:bladeNumber] was removed, no more
mezzanine card required on blade [value:bladeNumber].
OA: Fan Removed: Bay #[value:fanNumber]
OA: Fan Status Changed: Bay #[value:fanNumber] From: [degraded/failed/ok] To:
[degraded/failed/ok]
OA: Fan Subsystem Status Changed: From: [degraded/failed/ok] To:
[degraded/failed/ok]