HP ProLiant Gen9 - Page 397

To Next Page

To Previous Page

Microsoft Windows Event ID and SNMP traps 397

Log Severity: Error (3)

Log Message: Connectivity has been lost for the NIC in slot %1, port %2.

SNMP Trap: cpqNic3ConnectivityLost - 18012 in CPQNIC.MIB

Symptom: This trap is sent any time the status of a logical adapter changes to the Failed condition. This occurs

when the adapter in a single adapter configuration fails, or when the last adapter in a redundant

configuration fails. This can be caused by loss of link due to a cable being removed from the adapter or the

Hub or Switch. Internal adapter, Hub, or Switch failures can also cause this condition.

User Action: Check the cables to the adapter and the Hub or Switch. If no cable problems are found, the

adapter, Hub, or Switch may need replacement.

Supporting SNMP Trap Data:

• sysName

• cpqHoTrapFlags

• cpqNicIfPhysAdapterSlot

• cpqNicIfPhysAdapterPort

• cpqSiServerSystemId

• cpqNicIfPhysAdapterStatus

• cpqSePciSlotBoardName

• cpqNicIfPhysAdapterPartNumber

• ipAdEntAddr

• cpqNicIfLogMapIPV6Address

Supporting SNMP Trap Description: “Connectivity lost for adapter in slot [cpqNicIfPhysAdapterSlot], port

[cpqNicIfPhysAdapterPort].”

NT Event ID: 1292 (Hex)0x4435050C (cpqnimsg.dll)

Log Severity: Information (1)

Log Message: Redundancy has been increased by the NIC in slot %1, port %2. Number of functional NICs

in the team: %3.

SNMP Trap: cpqNic3RedundancyIncreased - 18013 in CPQNIC.MIB

Symptom: This trap is sent any time a previously failed physical adapter in a connected logical adapter

group returns to the OK condition. This trap is not sent when a logical adapter group has connectivity

restored from a Failed condition. The cpqNicConnectivityRestored trap is sent instead. This can be caused by

replacing of a faulty cable or connecting a cable that was disconnected.