Removal and replacement procedures 37
7. Remove the 92 × 32 mm system fan module.
To replace the component, reverse the removal procedure.
Upgrade fan module (92 x 38 mm)
To remove the component:
1. Power down the server (on page 25).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Place the server on its side.
4. Remove the access panel (on page 25).
5. If installed, remove the PCI air baffle (on page 27).
6. Remove the system air baffle (on page 28).
To Next Page
Loading...
