Removal and replacement procedures 42
7. If necessary for easier access to the cache module connector and/or removal of an air scoop, remove
the storage controller from the PCI riser cage or from the system board.
8. If the cache module is covered by an air scoop, remove the air scoop.
9. Disconnect the cache module backup power cable from the cache module.
10. Remove the cache module.
To replace the component, reverse the removal procedure.
HP Smart Storage Battery
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To prevent damage to electrical components, take the appropriate anti-static
precautions before beginning any installation, removal, or replacement procedure. Improper
grounding can cause electrostatic discharge.
To Next Page
Loading...
