Removal and replacement procedures 67
10. Remove the hot-plug power input module from the power supply bay.
To replace the component, reverse the removal procedure.
Redundant power supply blank
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
To remove the component:
1. Power down the server (on page 25).
2. Access the product rear panel.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the power supply or
power supply blank to cool before touching it.
3. Remove the power supply blank.
To Next Page
Loading...
