Removal and replacement procedures 36
2.
Install the full-height media device.
3. Connect the power cable and the data cable to the rear of the device.
4. Connect the data cable to the rear of the drive and to the SAS controller.
5. Remove the applicable bezel blanks from the bezel ("Bezel blank" on page 28).
6. Install the access panel.
7. Do one of the following:
o Close or install the tower bezel, as needed.
o Slide the server back into the rack.
8. Power up the server.
Hot-plug expansion hard drive cage and backplane
To remove the component:
1. Power down the server (on page 25).
2. Do one of the following:
o Open or remove the tower bezel, as needed ("Bezel" on page 27).
o Remove the server from the rack (on page 26).
3. Remove the access panel ("Access panel" on page 29).
4. Remove all hot-plug hard drives ("Hot-plug hard drives" on page 30).
5. Disconnect the power and data cables from the hard drive backplane and the system board ("System
board components" on page 77).
To Next Page
Loading...
