74 Reference and Troubleshooting Guide
Installing the Rack Server
To install the rack server:
1. Install the server into a rack ("Installing the Server into the Rack" on page
34
).
2. Connect the power cord and peripheral devices. Refer to Rear Panel
Components (on page 9
) for connector locations.
3. Power up the server ("Powering Up the Server" on page 21
).
4. Install the operating system ("Installing the Operating System" on page 41
).
5. Register the server. To register a server, refer to the registration card in the
HP ProLiant Essentials Foundation Pack or the HP Registration website
(http://register.hp.com
).
Accessing the Server in the Rack
Some installation or maintenance procedures may require the server to be
extended from the rack ("Extending the Server from the Rack" on page 22
)
before performing.
If the maintenance procedure requires accessing the server rear panel:
1. Unlock the cable management arm and swing the arm away from the server.
To Next Page
Loading...
