Hardware options installation 60
9.
The Torx screws required to install optical drives are located on the chassis.
10. For tower models, do the following:
a. Install the access panel (on page 23).
b. Return the server to an upright position.
11. For rack models, do the following:
a. Install the rack bezel (on page 22).
b. Install the access panel (on page 23).
c. Slide the server back into the rack.
12. Connect each power cord to the server.
13. Connect each power cord to the power source.
14. Press the Power On/Standby button.
The server exits standby mode and applies full power to the system. The system power LED changes
from amber to green.
15. Do one of the following:
o For tower models, install the bezel.
o For rack models, if removed, install the security bezel (on page 45).
Optical drive option
The server supports both DVD-ROM and DVD-RW drives.
1. Do one of the following:
o For tower models, open and remove the bezel ("Remove the tower bezel" on page 20).
o For rack models, if installed, remove the security bezel (on page 20).
2. Power down the server (on page 19).
3. Remove all power:
a. Disconnect each power cord from the power source.
To Next Page
Loading...
