HP ProLiant ML350p - Page 68

Hardware options installation 68
10.
Close the PCIe retainer latch.
11. Install the air baffle.
12. Install the access panel (on page 23).
13. Do one of the following:
o For tower models, return the server to an upright position.
o For rack models, slide the server back into the rack.
14. Connect each power cord to the server.
15. Connect each power cord to the power source.
16. Press the Power On/Standby button.
The server exits standby mode and applies full power to the system. The system power LED changes
from amber to green.
17. Do one of the following:
o For tower models, install the bezel.
o For rack models, if removed, install the security bezel (on page 45).
Graphic card option
The server supports up to three graphic card options. The server supports up to two double-wide graphic
cards.
For optimal performance, HP recommends that you install graphic card options in PCI slots 3, 6, or 8.
HP recommends the following:
• If the graphic card is populated in PCI slot 3, do not use PCI slot 2.
• If a single-wide graphic card is populated in PCI slot 8, do not use PCI slot 9.
• In a single-processor configuration, HP recommends installing the graphic card in PCI slot 3.
• In a two-processor configuration, HP recommends installing the graphic card in PCI slot 6.
• If a third graphic card is installed, HP recommends installing the third graphic card in PCI slot 8.