Hardware options installation 69
Installing a graphic card adapter option
1. Do one of the following:
o For tower models, open and remove the bezel ("Remove the tower bezel" on page 20).
o For rack models, if installed, remove the security bezel (on page 20).
2. Power down the server (on page 19).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
o For tower models, place the server on a flat, level surface with the access panel facing up.
o For rack models, extend the server from the rack (on page 23).
5. Remove the access panel (on page 22).
6. Remove the air baffle (on page 24).
7. Remove the fan cage (on page 26).
8. Select the appropriate PCIe slot to install the graphic card adapter.
9. Open the PCIe retainer latch.
10. Do one of the following:
o If you are installing a single-width graphic card adapter, remove one PCIe blank.
To Next Page
Loading...
