Hardware options installation 69
12.
Tighten both internal rack bezel thumbscrews.
13. Partially insert the CD-ROM drive horizontally into the slot below the media bay spacer.
14. Connect the IDE CD-ROM drive cable and power cable.
15. Push the CD-ROM drive all the way into the bay until the locking latch clicks into place, securing the
drive.
16. Install the media blanks horizontally in the bay below the CD-ROM drive.
NOTE: Install any optional tape drives ("Installing a half-height or full-height media device" on page 54)
instead of the media blanks at this time.
To Next Page
Loading...
