Power Switch
1. Prepare the computer for disassembly (Preparation for Disassembly on page 61).
2. Remove the computer cover (
Computer Cover on page 64).
3. Remove the fan shroud
Fan Shroud on page 103.
4. Raise the drive cage to its upright position.
5. Disconnect the cable assembly from the system board.
6. Squeeze the switch holder retaining clips together at the front of the chassis (1) and push the switch
assembly out of the chassis (2).
Figure 7-53 Removing the Switch Holder
To reinstall the switch holder, reverse the removal procedure.
ENWW Power Switch 105
To Next Page
Loading...
