Scanner Installation- HP Scanjet 4070 Photosmart.
Connect the scanner in the Order Shown:
1. Connect the USB cable to the scanner and to your computer.
2. Connect the cable that is already in the scanner, to its port on the back
of the scanner.
3. Connect the power supply to the scanner and plug it to a wall outlet.
Your computer will probably recognize the new hardware you have just installed
(the scanner) and will pop up a message Found new hardware.
The computer will look for a driver for the new scanner.
Now would be a good time to insert CD1- and move to Installing Scanner’s
Software.
Installing Scanner’s Software
Keep Clicking NEXT>>
When you get to locate driver files choose:
<>CD-ROM drive
After finding the driver, the computer will automatically start installing the
software from CD1.
Just follow the on-screen instructions, keep Clicking NEXT>> and at the end,
click FINISH.
To Next Page
Need help?
General
