Back to TOC Using accessories 79
Scanning from the XPA
You can scan slides or negatives using the XPA.
See the Setup and Support Guide for information about installing the
XPA.
See "Items for the XPA" on page 18 for information about preparing
items for the XPA.
Scanning slides
To scan standard 35 mm slides, use the XPA light source and the
positioning plate. When scanning fewer than three slides, you also
need the slide light shield.
To scan slides
1 With the XPA light source connected to its port on the scanner,
restart the software.
2 Place the positioning plate on the scanner glass so the arrow is in
the upper right-hand corner. Push the positioning plate toward the
top right corner.
3 Slide up to three slides into the slide holder on the bottom side of
the XPA light source. The correct view of the picture should be
facing outward, toward you.
Tip Do not use the XPA to scan a letter-size item, such
as a presentation transparency. Place the
transparent item on the scanner glass, place a white
piece of paper on top, and scan as you normally
would using the Scanner Glass command on the
Scan menu.
To Next Page
Loading...