4. Push the lamp bulb to one side slightly (against the spring), and lift it from the lamp housing.
Figure 7 Removing the bulb
Material disposal: mercury lamps
This HP product contains the following materials that might require special handling at end-of-life:
Mercury is present in the UV lamps. Disposal of mercury can be regulated because of environmental
considerations. For disposal or recycling information, please contact your local authorities or the
Electronic Industries Alliance (EIA) (
http://www.eiae.org).
Install the new UV lamp bulbs
1. Insert the replacement bulb into the lamp housing, pressing it to the left, and then down into
place.
Figure 8 Installing the bulb
2. Tighten the two screws that hold the reflectors together (see Figure 6 Reflector screws
on page 7 for screw locations).
8 User cleaning ENWW
To Next Page
Loading...
