7. Lubricate the lower carriage-wheel strip from end to end on the rail (moving the carriage to clean
the full length of the rail).
NOTE: Even if the oiled cloth appears clean, it should be discarded quarterly so that the oil
does not become sticky.
Figure 15 Lower carriage-wheel strip
8. To reset the maintenance counter for this task and complete the procedure, press Proceed.
Clean the print head orifice plates (bi-weekly)
NOTE: Users of printers in California must disregard all references to the Printhead Flush or IPA in
the instructions or when displayed on the control panel. Instead, the alternative cleaning liquid
specified at the beginning of this section must be used.
1. From the control panel (System page > Tools > User Cleaning and Maintenance), select
Clean Print Head Orifice Plates.
2. Process Proceed to continue.
14 User cleaning ENWW
To Next Page
Loading...
