5. Remove the screw (A in the figure below) that secures the wiper clamp to the wiper assembly.
6. Separate the two wiper clamp halves and remove the original wiper blade.
7. Install the replacement wiper blade in the orientation shown below.
Figure 25 Wiper clamp screw
8. Secure the wiper blade clamp to the wiper assembly using the original screw.
9. To reset the maintenance counter for this task and complete the procedure, press Proceed.
Drain waste from service station (quarterly)
Waste ink accumulates in the service station until drained. Dispose of the collected ink according to
local regulations.
1. Place the waste ink container (included with the printer) beneath the waste ink spigot, under the
media drive belt at the service end of the printer.
2. From the control panel (System page > Tools > User Cleaning and Maintenance), select
Drain Waste from Service Station.
3. Press Proceed to continue.
26 User cleaning ENWW
To Next Page
Loading...
