Floor load-bearing capabilities in the print production area are an essential consideration. This will
require consulting the structural engineer for the building in which the printer is to be installed. See
the
Specifications on page 12 for the shipping and assembled weights of the printer.
During installation, the printer and media tables will be leveled to ensure accurate media feeding. The
printer and table feet can be adjusted to compensate for a maximum floor slope (elevation change) of
5.6 cm (2.2 in) over the printer width, and 5.1 cm (2.0 in) over the printer depth.
Figure 2-1 Features and dimensions (FB500 shown, FB700 similar)
Table 2-2 Printer features
1 Input side
2 Output side
3 Service end
4 User end
5 Power cord inlet
6 Vacuum system auxiliary power outlet
Table 2-3 Printer and table dimensions
FB500 FB700
A Height 153 cm (60 in) 153 cm (60 in)
B Width 325 cm (128 in) 412 cm (162 in)
C Depth without tables 141 cm (56 in) 141 cm (56 in)
D Input table depth 52 cm (21 in) 52 cm (21 in)
E Output table depth 89 cm (35 in) 81 cm (32 in)
F,
G
Accessory table depth 165 cm (65 in) 89 cm (35 in)
H Table width 175 cm (69 in) 262 cm (103 in)
I Depth with input and output tables
installed
282 cm (111 in) 246 cm (97 in)
ENWW Facility requirements 5
To Next Page
Loading...
