from the ends, or lifted from the sides as needed. After unpacking, use the shipping casters to move
the printer, or lift the printer with a fork lift at the marked lift points.
Building interior clearances required
CAUTION: Due to its physical dimensions and weight, the printer cannot be moved through building
areas that cannot accommodate a fork lift, such as stairways or standard passenger elevators, or
through doorways that are narrower than the width of the printer or crate.
An Authorized Service Provider will install the printer. Depending on the space available at your
location, you can either unpack and assemble the printer in your receiving area, then move the printer
on its wheels to your production area, or move the shipping container unopened to your production
area, and unpack and assemble it there. A technical representative will work with you in advance to
plan for receiving, unpacking, and assembling the printer.
The route between the unloading area of the printer and the installation site, including any corridors
and doorways through which the printer must be transported, must be clear when the printer arrives.
When planning this area, take into consideration:
●
Height and width of entrance to unloading area
●
Width of any ramps between the receiving area and the installation location
●
Height and size of unloading dock
Use the following dimensions and weights as you plan to receive and move the printer to its final
location.
Table 2-4 Dimensions and weight of printer as shipped with pallet, crate, and packaging
FB500 FB700
Length 3.6 m (143 in) 4.4 m (171 in)
Depth 1.7 m (67 in) 1.7 m (67 in)
Height 1.8 m (72 in) 1.8 m (72 in)
Weight 1050 kg (2315 lb) 1223 kg (2695 lb)
Packaging
You must dispose of the crate and packaging material that comes with the printer. Most of these
materials are made of wood.
ENWW Receiving logistics 9
To Next Page
Loading...
