ENWW 9
Caldera
• Select the appropriate Resolution, Loading, Media, Mode and Quality.
• Open the job in Page Setup.
• Select proper Format and size the job. If needed set the image slightly larger
than the media dimensions, depending on the square-ness of the media.
• Confirm X and Y in Image size and position are set to 0.00.
• Select Print to send the job to the printer.
NOTE: there are other paths to adding overprinting to the file via the RIP (the Borderless media
option in Onyx and the Bleed option in Caldera), however the recommendation is to follow the
previous steps.
4. Once jobs are spooled to the printer hard drive select your job (Printing > Jobs) and select
Margins.
To Next Page
Loading...
