10 ENWW
5. Set the Left\Right\Leading\Trailing\top margins to negative values according to the added
overprint desired, as explained in the first paragraph of step 3 above.
NOTE: Left, Right, Leading and Trailing margins can be adjusted independently by using the
up/down arrows or by entering a custom margin with the keypad. It is recommended to use
equal Left and Right Margin settings for best results.
You can check if the margins have been set in the job info as you can see below.
6. Load the media and Print the stored job.
WARNING: To prevent a build-up of ink on the belt, clean immediately with isopropyl
alcohol (IPA). If ink is allowed to continue to cure, it will be necessary to soak the area
with IPA before it can be wiped off.
To Next Page
Loading...
