ENWW 11
Full bleed printing (maximum printer width)
When loading rigid media for edge-to-edge printing the media should be cut to the correct size,
have square corners and be loaded properly without the media being skewed or rotated. These are
ideal conditions to which there can always be some variation or error; applying overprint will help
achieve better results. Follow the steps below to perform full-bleed printing:
1. Create the maximum media width size sheet/roll in the RIP. Maximum width dimensions for
the different products are:
- FB550: 64.6 inches / 1640.8 mm
- FB750: 98.89 inches / 2511.8 mm
Follow the following steps to create the maximum width sheet/roll in the RIP:
Caldera
- Go to ServerAdmin.
- Select the printer and click Configure.
- Create a new sheet/roll (Available pages > New).
To Next Page
Loading...
