6 ENWW
2. Set Print Position to Centered: (Go to “Printing > Options > Print Position and Eject
Settings”) and set the print position to Centered as shown below.
3. Size the job slightly larger than the media dimensions depending on a variety of factors
such as the type of media and its square-ness. A recommendation would be to run a test
before a long print run. A good starting point would be to add approximately
3mm/0,125inch to each edge (left, right, leading and trailing).
For example, if the sheet size is 100x100cm (39.4 x 39.4 inch), image could be resized to
106x106cm (39.65 x 39.65 inch).
Image should be assembled considering overprint; there are two possibilities:
a. Size the image accordingly accounting for the needed overprint in a Graphic Design
Software, such as Photoshop, Illustrator, etc. and then RIP this image in 1:1 scale.
b. If image has not been sized considering the overprint in the Graphic Design
Software, then resize it in the RIP.
To Next Page
Loading...
