Table 2-1 Supported sheet configurations
Single image Multi-image Remaining copy 2-sided Nesting Eject settings
Single sheet Yes (N copies) No Yes Yes Yes Input, Output,
Off
Multi-sheet
(same
dimensions)
Yes (N copies) Yes Yes Yes No Input, Output
Multi-sheet
(different
dimensions)
Yes Yes No No No Output
Multi-sheet printing (same dimensions)
Multiple copies of a single image can be made by setting the quantity to a number equal to or greater than
the number of the sheets you loaded. The printer prompts you to load more sheets until the number of
copies you specified has been printed. You can print any number of copies in this configuration, even if the
total number does not divide evenly into the number of sheets per row. Only the last row may have a
different number of sheets.
The Multi-Image feature is enabled by selecting the Print 2-Sided / Multi Image N-Up button in the lower
right corner of the Stored Jobs screen, then selecting Multi-Image N-Up in the following screen. Each of the
jobs across the belt can be different jobs, but all jobs must have the same color set and resolution. Once the
first job is selected, the printer displays jobs with a color set or resolution mismatch with a red border. If a
different print mode is desired, or if separate jobs have different print modes but share the same resolution,
a single print mode is changeable by selecting Print Mode in the summary screen. Enter the number of image
groups or ‘rows’ to be printed and press Proceed.
Multi-sheet printing (different dimensions)
As with multi-sheet printing with the same dimensions, multiple copies of a single image can be made by
setting the quantity to a number equal to or greater than the number of the sheets you loaded. Because
18
Chapter 2 Configure and load media ENWW
To Next Page
Loading...
