10. Enter the media length or press Cancel for an undefined length.
The printer measures the media width.
11. On the Front Page screen, press Proceed.
The Front Page screen appears on the control panel.
Use the camera to locate the media
For roll-fed media, you can choose between two levels of precision for finding the left (user end), and right
(service end) edges of the media.
1. On the Printing page, press Options.
2. From the Options menu, press Measure Media.
The Measure Media Frequency menu appears. This enables you to select a trade-off between image
placement accuracy and throughput.
●
When loading — Locates the left and right edges only when loading a roll of media.
●
Before each copy — Locates the left and right edges of the media before each print. This enables
the printer to compensate for any “drifting” of the media, and print the image at the correct
location.
Check Media Skew — the printer measures the skew of the media when measuring the width
when the media is loaded or reloaded. The feature is disabled when Before each copy is enabled.
3. Press a Measure Media Type option.
The Options menu reappears.
20 Chapter 2 Configure and load media ENWW
To Next Page
Loading...
