80 Zoning Configuration
Renaming a zone
To rename zone_1 to zone_a, enter the zone rename command, as shown in the following example:
SN6000 FC Switch #> admin start
SN6000 FC Switch (admin) #> zoning edit
SN6000 FC Switch (admin-zoning) #> zone rename zone_1 zone_a
SN6000 FC Switch (admin-zoning) #> zoning save
Copying a zone
To copy the contents of an existing zone (zone_1) to a new zone (zone_2), enter the zone copy
command, as shown in the following example:
SN6000 FC Switch #> admin start
SN6000 FC Switch (admin) #> zoning edit
SN6000 FC Switch (admin-zoning) #> zone copy zone_1 zone_2
SN6000 FC Switch (admin-zoning) #> zoning save
Adding members to a zone
To add ports/devices to zone_1, enter the zone add command, as shown in the following example:
SN6000 FC Switch #> admin start
SN6000 FC Switch (admin) #> zoning edit
SN6000 FC Switch (admin-zoning) #> zone add zone_1 alias_1 1,4 1,5
SN6000 FC Switch (admin-zoning) #> zoning save
Removing members from a zone
To remove ports/devices from zone_1, enter the zone remove command, as shown in the following
example:
SN6000 FC Switch #> admin start
SN6000 FC Switch (admin) #> zoning edit
SN6000 FC Switch (admin-zoning) #> zone remove zone_1 alias_1 1,4 1,5
SN6000 FC Switch (admin-zoning) #> zoning save
To Next Page
General
