To replace the side access panel, align the bottom groove of the side access panel with the bottom edge
of the chassis, rotate the side access panel toward the chassis and press firmly until the latch engages.
Front Bezel
1. Lift up on the two release snaps (1) located on the front bezel.
2. Rotate the front bezel away (2) from the chassis to remove the bezel.
Figure 4-7 Opening the front bezel
To replace the front bezel, align front bezel on the bottom and rotate in until it snaps into place.
Bezel blanks
To remove the bezel blanks:
1. Disconnect power from the system (
Predisassembly procedures on page 57) and remove the front
bezel (
Front Bezel on page 63).
2. Gently push the subpanel (1) out the back of the front bezel.
3. Remove the desired bezel blank by applying outward pressure on the subpanel (1) and pulling the
blank (2) away.
Figure 4-8 Removing the bezel blanks
ENWW Steps for removal and replacement of components 63
To Next Page
Loading...
