If removing another type of PCI Express card, lift the card out of the chassis. You do not need to
press in on the “hockey stick” lever.
4. Install a PCI slot cover and close the PCI levers. If the PCI levers do not close, be sure all cards
are properly seated and then try again.
Figure 4-23 Removing the PCI Express card
To install a PCI Express card:
1. Disconnect power from the system (
Predisassembly procedures on page 57), remove the side
access panel (
Side access panel on page 62), and remove the PCI retainer (PCI retainer
on page 74), if installed.
2. Lift the PCI levers (1) by first pressing down and then up.
3. Remove the PCI slot cover (2).
4. Lower the PCI (3) card into the chassis. Verify that the keyed components of the card align with
the socket.
76 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
