Sliding Rack Mount Kit Installation
Page 6 of 20
Installing on Threaded Hole Racks
NOTE: This product must be mounted in the middle of a 4U space. Use the mounting aid at the end of this
document to determine a 4U space and mark the center.
1. Remove the three pins from the rear slide mounting bracket using a flat blade screwdriver 1.
2. Remove the three pins and two nuts from the front slide mounting bracket 2.
3. Attach the rear slide mounting bracket to the rear rack column (screws provided by your rack
manufacturer) 3.
4. Attach the front slide mounting bracket to the front rack column (screws provided by your rack
manufacturer) 4.
3
1
A
4
2
To Next Page
Loading...
