REMOVAL AND REPLACEMENT OF COMPONENTS 103
Chapter 4
INTALLING A SATA HARD DRIVE
For more information on SATA hard drives and the SATA RAID configuration, see Appendix B, “SATA
Devices,” on page 155.
1 Select a drive bay in which to install the drive. Squeeze the green tabs and slide the rails out of the
empty bay.
2 Attach the rails to the hard drive by aligning the notches with the holes and squeezing it into place
(see image on page 101).
3 Push the drive into the selected bay until it snaps into place.
4 Attach the power cable and data cable to the drive.
5 Connect the data cable to the serial ATA port.
To Next Page
Loading...
