REMOVAL AND REPLACEMENT OF COMPONENTS 91
Chapter 4
PCI or PCI Express Installation
1 Disconnect power from the system (page 68), remove the access panel (page 74), lay the
workstation on its side with the system board facing up, and remove the PCI retainer (page 88).
2 Lift the PCI levers 1 by first pressing down on them and then out.
3 Remove the PCI slot cover 2.
4 Lower the PCI 3 or PCI Express 3 card into the chassis. Verify that the keyed components of the card
align with the socket. If installing a PCI Express card, plug in the power supply cable, required.
5 Close the PCI levers. If the PCI levers do not close, be sure all cards are properly seated and then try
again.
6 If installing a PCI Express card, plug in the power supply cable, if required.
Figure 4-2 PCI Installation
Figure 4-2 PCI Express Installation
1
2
3
3
4
4
5
1
2
To Next Page
Loading...
