6. For a SAS hard drive, attach a SAS-to-SATA cable adapter to the connector on the hard drive.
Figure 4-42 Attaching the SAS-to-SATA cable adapter
7. Insert the SAS controller card into an available PCI expansion slot.
8. Connect one end of the SAS data cable to the controller card and the other end to the SAS hard
drive, as shown in the following illustration. Also attach a power cable (not illustrated).
Figure 4-43 Connecting data cable to SAS controller card
90 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
