3. Push the top cover toward the rear of the chassis and lift the cover up 2.
Figure 4-8 Removing the Top Cover
Hood sensor (Smart cover sensor)
To remove the hood sensor:
1. Disconnect power from the system (
Predisassembly procedures on page 57) and remove the side
access panel (
Side access panel on page 63).
2. Disconnect the white 1x3 hood sensor connector from the in-line connector attached to the front
panel harness.
3. Slide the hood sensor forward.
4. Slide the hood sensor forward, push it down, and remove it from the chassis.
Figure 4-9 Removing the hood sensor
To replace the hood sensor, reverse the previous steps.
66 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
