4. Remove the four screws 1 from the back panel.
5. Slide the power supply toward the front 2 and lift up 3 to remove it from the chassis.
Figure 4-17 Removing the power supply
To install the power supply, reverse the previous steps.
Memory
Memory module requirements
●
Use only industry-standard, registered PC2-5300F DIMMs
●
Match DIMM pairs by size and type
●
No support for unbuffered memory
Removing memory module
1. Disconnect power from the system (Predisassembly procedures on page 57), remove the side
access panel (
Side access panel on page 63), and remove the memory fan (Memory fan
on page 69).
CAUTION: To ensure that memory modules are not damaged during removal or installation,
power off the workstation and unplug the power cord from the AC power outlet. Wait until the LED
on the back of the power supply turns off before removing memory. If you do not unplug the power
cord while installing memory, your memory modules might be damaged and the system will not
recognize the memory changes.
2. Gently push outward 1 on the socket levers.
72 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
