3. Attach the rails to the hard drive. Align the pins on the rails with the hard drive holes and snap the
rails into place.
CAUTION: Do not damage the PC board on the bottom of the hard drive with the pins on the
rails.
Figure 4-40 Attaching the rails to the hard drive
4. Push the drive 1 into the selected bay until it snaps into place.
5. For a SATA hard drive, attach a data cable 2 from a SATA connector on the system board to the
hard drive, and attach a power cable (not illustrated) to the drive.
Figure 4-41 Replacing the SATA hard drive
ENWW Removal and replacement of components 89
To Next Page
Loading...
